AQUA LUNG LOOK 2 MASK

If you wear corrective lenses, the Look 2 is your user-friendly mask solution for ensuring you fully take in every inch of viz on your dives. Our patent-pending frame allows you to quickly change out lenses in a wide range of positive and negative diopters (sold separately in +3.0 to -10.0 lenses).

• Twin Lens Design 
  Individual lenses accommodate differing optometrical needs for your right and left eye. Low volume for reduced buoyancy and easy clearing.
• Cardanic Joint Buckles 
  The joints between the mask and strap rotate in both vertical and horizontal directions for a customized, pinch-free fit.
• Push-Button Strap Security 
  Counterposed push-button activation makes strap adjustments fast and holds the strap securely in place once set. Easy to use, even while wearing gloves.
• Superior Headpiece Fit 
  The wide headpiece on the Mission’s silicone strap conforms to your head to ensure a comfortable, secure fit.
• Natural Skirt Fit 
  High-grade silicone facial skirt flexes to mold naturally along the contours of your face for a comfortable, leak-free seal.
• Tempered Glass Lenses 
  For your safety and the mask’s longevity, the lenses are made of tempered glass to guard against cracks and shattering, even under pressure and stress. Meets ANSI standards.

How to properly care for your Aqua Lung mask:

Care Before the Dive:

• During the manufacturing process, a thin film of silicone will develop on the glass lens. This film of silicone will cause rapid fogging that is resistant to conventional anti-fog measures. It is important to remove this film of silicone from the lens prior to your first dive. To remove the film you will need to scrub the lens inside and out with a mild abrasive. A paste toothpaste is ideal but a liquid scrub will also work. Rub the cleanser into the lens with your fingers several times and then rinse clean thoroughly.

• Mask fogging is a normal occurrence, even after the film of silicone has been removed. Normal fogging can be easily prevented with after market anti-fog agents or saliva. Rub onto the lens and then rinse. Your dive will now be fog free!

• Some after after-market anti-fog agents contain formaldehyde, alcohol, or other substances that may damage the plastic materials used in your mask. If unsure, avoid prolonged exposure of the anti-fog agent with the plastic parts of your mask.

Care During the Dive:

• When entering the water either from a boat or a beach, place a hand over the lens of your dive mask and hold it securely in place. This will help ensure your mask stays in place during entry and will help deflect any direct impact of water on the lens caused by the jump into the water or any approaching waves.

• A typical dive staging area is a dangerous place for dive masks. Care should be taken to not leave your mask in a location where it might be exposed to dropping weight belts or tanks.

• It is best to avoid putting your mask on your forehead at any time during the dive. Several factors can cause the mask on your forehead to be dislodged and subsequently lost. If you want to temporarily remove the mask from your face, place the mask around your neck.

Care After the Dive:

• Soak in warm fresh water (not over 120°F) to dissolve salt crystals.

• Rinse thoroughly with fresh water and towel dry before final storage.

Storage:

• Store in a cool, dry and protected place out of direct sunlight.

• Store separated from other dive gear as the black pigmentation of other equipment may discolor the clear silicone skirt of your mask.

Chemicals/Solvents:

• Avoid any contact with alcohol, oil, gasoline, aerosols, or chemical solvents.
• Do not expose any part to aerosol spray, as some aerosol propellants attack or degrade rubber and plastic materials.
• Do not use any type of alcohol, solvent or petroleum based substances to clean or lubricate any part.
• Do not store your equipment near any oil, gasoline, chemicals, or solvents.